|
Replacing the fuser
The fuser is located at the rear of the printer. Be sure to let the fuser cool down for 15 minutes before removing. Always remove the mains cable before changing the fuser.
1. If a duplexer (for double sided printing) is fitted remove it by lifting slightly up and then pulling straight back until it is clear of the printer.
2. If a duplexer is not fitted, remove the dust cover. (Photo no.1).
3. Remove the rear cover/output tray (Photo no. 2), by locating a hinge pin on either side and gently prying it out from the black plastic fuser chassis.
4. Move the 2 blue plastic retaining clips to the unlocked position (see arrow embossed on clips). (Photo no. 3)
5. Pull the fuser assembly straight out of the printer.
6. Slide the new fuser into position and move the blue retaining clips to the locked position. Replace the rear cover/output tray/duplexer.
|
