|
Replacing the fuser
The fuser is located at the rear of the printer. Be sure to remove the mains cable to the printer and let the fuser cool for at least 15 minutes before removing.
1. If a duplexer (for double sided printing) is fitted remove by lifting up slightly and pulling out from the printer.
2. If a duplexer is not fitted remove the rear output tray (photo no. 1).
3. Locate the 2 blue fuser locking catches. Release by pushing up both catches hard to be sure they have fully released (photo no. 2).
4. Pull the old fuser straight out from the printer.
5. Slide the new fuser into position being sure that both blue latches click firmly into place.
6. Refit the rear output tray or duplexer as applicable.
|
