LASERJET 4200/4250/4300/4350

PAPER FEED KIT

FITTING INSTRUCTIONS

Replacing the Tray 1 (multipurpose tray) pickup roller and separation pad

1. Open the toner lid and tray 1.

2. Remove the white plastic cover (usually labelled with a “4”) (if fitted) above the pick up roller by grasping the handle and pulling straight out.

3. Release the pick up roller by bending out the 2 small white plastic locking tabs (one on each side) simultaneously using 2 pens or small screwdrivers (photo no.3). Once the tabs have been released the roller should pop of its mounting. Replace the separation pad before putting on a new pickup roller.

4.Remove the separation pad by inserting a small flat blade screwdriver under the pad and prising upwards carefully. (photo no.5).

5. Fit the new separation pad locate it in position above it black plastic support arm and applying gentle downward pressure until it clicks into place. It should be level and not raised on one side.

6. Fit the new pick up roller by fitting the locating pins (part of the blue plastic) into their cut-outs on the white plastic assembly and then clicking the white plastic locking tabs into place.

Fitting Tray 2/3 pickup and feed rollers

1. Remove the feed roller from inside the paper tray by opening the hinged cover to the left of the roller to gain access. The Pickup roller is held on its shaft by a plastic retaining clip which locates in a groove on the metal shaft. Lift the clip out of the groove and slide the roller to the left to remove (photo no.7). Fit the new roller by pushing on until the retaining clip clicks into place.

2. To change the rollers inside the printer remove the paper drawer and turn the printer on its left side to give easier access. The 2 rollers are removed in similar fashion to the one in the paper drawer. When fitting the new rollers be sure to place the pick up roller (white center) and feed roller (blue center) in the correct locations (photo no.8).

www.LaserInk.co.uk